Avolites Tiger Touch Operator's Manual download pdf (Page 82)

Page 82 – 4. Controlling dimmers and fixtures

TitanUniversal_Man_v8-0_TT.doc 05 August 2014

if you have 12 fixtures across the stage in 3 groups of 4, you may

want a fan of light beams spread evenly across the stage, or you may

want 3 groups of separately fanned light beams.

By holding down the Fan button you can select:

• [Ignore Groups] All fixtures are fanned as one large group

• [Fan Group as Fixture] All fixtures in a group take on the same

value.

• [Fan Within Group] Fan runs across individual fixtures in each

group.

Holding down the Fan button also allows you to select the Curve used

for the fan. The different curves allow you to obtain different fan

effects.

Fan mode needs to be used on at least 4 fixtures to give good effects.

If you have an odd number of fixtures, the central fixture will not

change in fan mode.

Press the Fan button again to leave Fan mode. Any effects you have

set will remain in the programmer.

It’s fairly easy to accidentally leave Fan mode turned on

and be very confused about why the wheels aren’t

working properly, so turn it off as soon as you have

completed the effect. To avoid this there is a User

Setting ‘Press and hold Fan’. If enabled, you have to

hold down the Fan button to enable Fan mode. See

section 12.3.3 on page 202.

Fan Curves

You can select different curves to use when in Fan mode. Hold down

the Fan button and select [Curve], the options are:

• Line: Traditional fan, the first and last selected fixture are

affected equally in opposite directions, the midpoint remains

unchanged. This is most useful for pan.

• Pull Middle - The first and last selected fixture remain at the

current value, the midpoint is affected most. This is useful for

colour mixing, tilt and dimmer.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 260 261

No comments

Avolites Tiger Touch Operator's Manual Page 82