Avolites Tiger Touch Operator's Manual download pdf (Page 173)

9. Cue Lists - Page 173

TitanUniversal_Man_v8-0_TT.doc 05 August 2014

9.5.5 Running a cue list to timecode

The console can run a cue list automatically to a timecode. This is

very useful for complex performances which must be exactly the

same time after time, or for unattended operation. Each step in the

cue list is assigned a time at which it will run.

The timecode can be read from the system clock, from an internal

timecode source, from MIDI or from Winamp. Internal timecode is

useful for programming a sequence which will later be triggered by an

external timecode source.

1> Connect the cue list for which you want to set timecode.

2> Press [Timecode] on the top-level menu.

3> Press softkey A to select the desired timecode source.

4> Press [Record].

5> Start the timecode source. If using internal timecode, press

[Play] to start it.

5> Press the red Go button to step each cue at the time you wish

the cue to start.

6> Press [Record] when you have finished.

To play back a timecoded cue list, press [Connected Cue Lists] and

select the cue list which is to be played. Then press [Timer

Disabled/Enabled] to enable the timecode input.

When you start the timecode source (or press [Play] if using internal

timecode), each cue will fire as the timecode matches its

programmed time.

You can edit the timecode for each cue by using Wheel A to select the

cue, then press Enter and type the new timecode for the cue.

While editing a time you can also use Wheel B to select multiple cues,

and use the softkey options to enter a value to change the time of all

the cues (offset, add a fixed time or subtract a fixed time).

You can open a timecode display window to show you the incoming

timecode – press [Open Workspace Window] then [Timecode].

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 260 261

No comments

Avolites Tiger Touch Operator's Manual Page 173