Avolites Tiger Touch Operator's Manual download pdf (Page 67)

4. Controlling dimmers and fixtures - Page 67

TitanUniversal_Man_v8-0_TT.doc 05 August 2014

cues you store. If the option is set to “Clear” then the Located

attributes will not be stored in the Programmer unless you

modify them using the wheels. This is useful if for example you

want to program a cue which sets the position of fixtures, but

does not turn them on. The Locate button will light up the

fixtures for programming, but the lit state will not be stored in

any cues you save.

To quickly locate without changing pan/tilt, hold Locate

and press the Pan/Tilt (or Position) button, then release

Locate.

To quickly locate pan/tilt only, hold Locate, press

Attribute Options (just above Locate), then press

Pan/Tilt (or Position), then release Locate.

Changing the locate state

You can permanently change the locate state of each fixture by

recording a new Locate State. This can be shared (applies to all

fixtures of the same type) or individual. To store, set up the desired

locate state, then press Record, then Locate. Select [Shared] or

[Individual] from the softkeys. Press Record or Locate a second time

to confirm.

4.1.3 Clearing selection

The Clear button (on the right of the numeric keypad) is used to

remove all changes from the Programmer and deselect all fixtures. A

quick press of the Clear button just clears everything, however if you

hold down the Clear button, then more options are available.

• You can mask which attributes are to be cleared (for example,

leaving the pan/tilt in the programmer but clearing everything

else) by holding down Clear and pressing [Set Mask to Clear

Nothing]. Then (still holding Clear) turn on the Attributes you

want to change using the Attribute Bank buttons down the right

hand side, or press [Set Mask] and use the softkeys. Only the

lit attributes will be cleared. Pressing the Attribute Options

button will clear the mask. The Time mask option allows you to

clear or retain the fade/delay times in the programmer for all

attributes (clearing individual attributes will also clear times for

that attribute, for example setting a P mask will clear position

times).

• [Clear Options] opens a submenu showing some further options

(described below).

• [Clear All Fixtures/Selected Fixtures] sets whether all fixtures

will be cleared from the programmer, or if only currently

selected fixtures will be cleared. This is useful if you want to

clear specific fixtures.

• [Individual Attributes] allows you to clear individual attributes

from the Programmer. When you press the softkey, you are

given a list of attributes in the Programmer – press the

appropriate softkey to clear that attribute.

• [Clear All Programmers] will clear all programmers that are

currently active on the console. This will be used for multi-user

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 260 261

Comments to this Manuals

No comments

Avolites Tiger Touch Operator's Manual Page 67

Comments to this Manuals

Related products and manuals for Audio mixers Avolites Tiger Touch