Avolites Tiger Touch Operator's Manual download pdf (Page 66)

Page 66 – 4. Controlling dimmers and fixtures

TitanUniversal_Man_v8-0_TT.doc 05 August 2014

• Once you have changed any attribute, pressing a Select button

will deselect all fixtures and start the selection process again.

All previously selected fixtures (since you last pressed Clear)

stay in the programmer. Once a fixture has been edited, the

button shows a darker blue (also on the HUD). The picture

below shows the first two fixtures selected, with the second

three in the programmer and the others unselected.

• You can select fixtures on another page by touching one of the

page buttons to the left of the fixture buttons, if you have

'Pages' set to Show (using the context button to the left of the

menu buttons). Otherwise you can use the scroll slider to show

other pages.

• Using Key Profiles (see section

12.2.1 on page 200) you can set

the fixture touch button to latch mode so that it turns the

fixture’s dimmer channel on (like putting a preset fader to full).

4.1.2 Setting fixtures to a start position (Locate)

The Locate button (the button on the bottom right corner of the

console) is used to put the fixture into a known position with light

coming out, so that you can start programming it.

A quick press of the button will move all selected fixtures to a central

position and reset all the attributes so that you get a white light.

However you sometimes might not want to move the fixture, and by

holding down the Locate button, you get some more options.

• You can mask off some of the Locate settings (such as only

turning the fixture on, but not changing its position or colour)

by holding down Locate and pressing [Set Mask to Exclude All].

Then (still holding Locate) turn on the Attributes you want to

change using the Attribute Bank buttons down the right hand

side. Only the lit attributes will be changed by Locate. Pressing

the Attribute Options button (just above Locate) will clear the

mask.

• Option [Auto Reset Mask] sets the mask to be automatically

reset to include everything each time Locate is pressed, or you

can toggle the option to [Remember Mask] which will keep the

mask setting you used last time.

• Option [Clear/Don’t Clear Located Attributes] sets whether the

attributes changed by the Locate function will be saved into any

Scroll slider

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 260 261

No comments

Avolites Tiger Touch Operator's Manual Page 66