Avolites Tiger Touch Operator's Manual download pdf (Page 236)

Page 236 – 16. Release notes

TitanUniversal_Man_v8-0_TT.doc 05 August 2014

Filter relevant palettes: There is a new user setting option [Filter

Relevant Palettes Enabled/Disabled]. When Enabled (default)

selecting fixtures or groups will cause non-applicable palettes to grey

out in the palette workspaces. This makes it easy see which palettes

are available, particularly when you have large numbers

Highlight active palettes: There is a new user setting option

[Highlight Active Palettes Enabled/Disabled]. When Enabled (default)

palettes in the programmer will highlight in the touch workspaces and

in the HUD in the same way that fixtures or groups do. This makes it

easy to see which palettes you have selected.

Offset: It is now possible to set an offset for any attribute of any

fixture. Offsets to attributes are applied to channels just before final

output. The most popular use for this is to provide a quick way to

globally modify pan values when fixtures are hung in orientations that

don't match the current programming. This might occur when

exchanging fixtures between venues, when preprogramming without

access to the physical fixtures in advance (or understanding how they

will be hung) or where fixtures are at unusual angles (for example a

45 degree boom).

A new option has been added to the Attributes Behaviour context

menu in Patch View. Selecting this will show any offsets applied to

the attributes of the fixtures/lines in view. Selecting a cell will open

the Set Offset menu. From here you can input an offset %

numerically or by wheel. When inputting numerically there is a sofkey

to toggle between a negative and positive offset. There is also a

[Reset Offset] softkey to reset the offset to zero. Alternatively you

can adjust the offset of fixtures and attributes via Patch/[Edit

Fixtures].

A new softkey option [Set Offset] has been added to the Edit Fixtures

menu. Pressing this will prompt you to select fixtures. Once fixtures

have been selected you can then choose which attribute you want to

apply an offset to. You can filter the available attribute options by

pressing the attribute bank keys. After selecting an attribute you will

be presented with the same Set Offset menu and options as when

selecting a cell in attribute behaviour/offset. A third way to set an

offset is by using locate: Select fixtures, locate, adjust attributes to

the desired locate value (for example wheel pan until it is straight)

then press record, locate, [Update Offset]. This is a quick and

intuitive way of setting an offset. Note that this does not change the

actual locate value. Instead it looks at the difference between the

current locate value and the new value and sets that as an offset.

Finally, you can do a similar thing using palettes: Select fixtures,

apply palette, adjust attributes to desired value then press Record,

Palette, [Update Offset]. Again, this does not change the palette but

instead looks at the difference between the value in the palette and

the new value and applies this as the offset

Convert cue: It is now possible to convert a cue into a cuelist or

chase. If you press record and then select a cue two softkeys have

been added to the 'Cue Exists' menu. Now, in addition to [Cancel],

[Merge] and [Replace] there is [Convert to Cue List] and [Convert to

Chase]. Selecting either of these options will change the cue to the

respective choice and add the contents of the programmer to cue 2

(cuelist) or step 2 (chase). The relevant record menu will also then

open allowing you to continue adding steps as normal. In the case of

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 260 261

Avolites Tiger Touch Operator's Manual Page 236

Comments to this Manuals

Avolites Tiger Touch Operator's Manual Page 236

Comments to this Manuals

Related products and manuals for Audio mixers Avolites Tiger Touch