Avolites Tiger Touch Operator's Manual download pdf (Page 163)

9. Cue Lists - Page 163

TitanUniversal_Man_v7-0_TT.doc 03 September 2013

• The [Delay Out] setting of the cue would normally be used if

the console links automatically to the next cue, and sets a wait

time before the next cue starts its fade in. So the outgoing cue

would start to fade out, and the delay out time would run

before the new cue begins its fade in.

9.5.2 Cue linking & Link Offset

Cues in cue lists may be linked together, allowing you to build up

complex self-timed sequences. The link options are set using the

softkeys and are:

• [Link Wait For Go]: the cue waits for the Go button to be

pressed then fires immediately. Link Offset is disabled.

• [Link After Previous Cue]: The cue fires when the previous cue

has finished its delay in and fade in times. A Link Offset can be

set to add a delay between the previous cue finishing and this

cue firing. The offset can be given as a time in seconds, or as a

percentage of the fade time of the previous cue.

• [Link With Previous Cue]: The cue fires at the same time as the

previous cue fires. A Link Offset can be set to add a delay

between the previous cue firing and this cue firing, set either in

seconds or as a percentage of the fade time of the previous

cue.

These options allow you to create complex self timed sequences by

building up simple steps. For example if you wanted the following

effect:

• Go is pressed, fixture one starts fading up over 20s

• After 10s fixture two fades up over 15s

• Both lights stay on for 5s

• Both lights go off in 3s

You could program

• Cue 1 - Fixture 1 @ 100%, Fade In 20s, Link Wait For Go

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 255 256

No comments

Avolites Tiger Touch Operator's Manual Page 163