Avolites Tiger Touch Operator's Manual download pdf (Page 159)

9. Cue Lists - Page 159

TitanUniversal_Man_v7-0_TT.doc 03 September 2013

then the select button for the cue list), or use Unfold (next section),

or you can use a command-line style series of keypresses.

Copy/Move within the same playback:

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] @ <cue> ENTER

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] ENTER <cue> ENTER

Copy/Move to the end of the same playback:

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] @ @

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] ENTER ENTER

Copy/Move to a different playback:

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] [@][ENTER] <playback> <cue> ENTER

Copy/Move to the end of a different playback:

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] [@][ENTER] <playback> ENTER

• COPY/MOVE <playback> <cue> [THRO <cue>] [NOT <cue>]

[AND <cue>] [@][ENTER] <playback> <playback>

(<playback> is a playback swop key, <cue> is the cue number and

sections in square brackets are optional)

9.3.4 Editing a cue list using Unfold

The Unfold button places each cue of the cue list on one of the

playback faders. This allows you to fire and edit each step individually

as if it was a stand-alone cue.

1> Press the Unfold button, then the Select button of the cue list to

be edited.

2> The first 10 cues are loaded into the playback faders. The

display shows the cue numbers and legends.

3> Raise a playback fader to output the contents of that cue (fade

times will operate as programmed).

4> Various Unfold options are available, the details are below.

5> Press Unfold again to get out of unfold mode.

• To edit the contents of a cue: Press Clear to empty the

programmer, raise the fader to output the cue, make the

changes, press [Record Step], then the Select button for the

cue number.

• To merge the programmer into the live step, double tap [Record

Step].

• To change the times or cue linking for the cue, press [Edit

Times], then the Select button for the cue, then set the times

(see Timing on the following page)

• To Insert a new cue, set up the look for the new cue, press B

[Insert Step], then press the playback button where you want

the new cue to go. All following cues will be shifted on by one

and the new cue will be given a number in between the two

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 255 256

Comments to this Manuals

No comments