Avolites Tiger Touch Operator's Manual download pdf (Page 145)

8. Chases - Page 145

TitanUniversal_Man_v7-0_TT.doc 03 September 2013

8.2.2 Connecting a chase for control

When you fire a chase, the wheels and Stop/Go buttons are

automatically allocated to control the speed and crossfade of the

chase – this is called Connecting the chase. If you have more than

one chase running, you can choose which chase is connected to the

controls using the Connect button.

• Connect a different chase to the controls by pressing the

Connect button then the Swop button of the chase you want to

control.

• Disconnect a chase from the controls by double pressing the

Connect button.

• You can turn off the “chase autoconnect” option in the User

Settings menu if you don’t want to connect to a chase when

you fire it. You will have to use the Connect button to control

the chase if you do this.

• Normally if you change the speed or crossfade of a chase, the

new setting is saved. However you can set this change to be

temporary, so that when the show is reloaded the speed and

fade will go back to the previously saved settings. Go to User

Settings (Avo button + [User Settings] and set option C to

[Connected View Sets Temporary Chase Speed]. You can still

save a temporary speed by pressing [Save Temporary Speed]

in the Set Times menu.

8.2.3 Setting speed and crossfade for a chase

The left wheel is assigned to control the speed of the chase it is

connected to. The speed is shown in Beats Per Minute (BPM) on the

display. You can also enter a speed from the keypad as described

below. The last speed you set on the wheel is always remembered,

you do not have to tell

the Tiger Touch to save it.

Crossfade is the “slope” between cues; with a crossfade of 0, the

fixtures snap instantly to the next cue, but with a crossfade of 100,

the fixtures spend the whole cue time fading to the next cue. With a

crossfade of 50, the fixtures delay for half the cue time and fade for

the other half of the time.

You set the crossfade and speed as follows:

1> Press [Edit Times] from the top level menu then the Swop

button of the chase.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 255 256

No comments

Avolites Tiger Touch Operator's Manual Page 145