Avolites Titan One User Manual download pdf (Page 170)

Page 170 – 10. Running the show

TitanUniversal_Man_v7-0_TM.doc 02 September 2013

• Local (default - no Speed Master)

• BPM 1-4 (override the local speed with a fixed value from the

master)

• Rate 1-4 (proportionally modify the local speed using the

master)

There is also a Rate Grand Master which, if used, proportionally

controls the four Rate Masters (BPM Masters are not affected).

To use Speed Masters you will need to assign some handles on the

console to act as the Speed Master faders. Switch the console to

System mode and select [Assign Mastering]. Special key profile

options are available for Speed Masters, BPM Masters default to Tap

Tempo.

10.1.5 Group Masters

You can assign a fader to control the master intensity of each fixture

group. To do this you simply save (or move) the group button to a

handle with a fader.

The blue button will then select fixtures in the group and holding the

blue button gives you softkey options to filter the selection according

to a pattern.

Using the [Playback Options] command you can set the fader mode

to the following:

• Scale master (proportional control)

• HTP (override level if higher than current output)

• Limit (sets hard limit)

• Take Over (place fixture and its intensity in programmer when

level matched)

• Disabled (ignore fader)

If the playback fader has a display area on the screen, the level and

mode of the master will be shown.

• When a group master is set to disabled or moved to a handle

without a fader, it will become locked at the current fader level.

Re-enable or move back to a fader to adjust the level.

10.1.6 Flash and swop buttons

The Flash and Swop buttons on the playback faders may be used at

any time to flash and solo cues and chases. The Flash button adds

the playback into the current output, the Swop button turns off all

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 250 251

No comments

Avolites Titan One User Manual Page 170