Copyright Avolites Limited 2011
Page 82 – 7. Chases
TitanMobile_Man_v4-0.doc 07/04/2011 13:46:00
7.3.2 Editing a chase using Unfold
Titan Mobile has a powerful chase editing system. The Unfold button
places each cue in a chase on one of the playback faders, allowing
you to fire and edit each cue individually as if it was a stand-alone
cue. Unfold also allows you to set individual timing for cues in the
chase.
1> Press the Unfold button, then the Swop button of the chase to
be edited.
2> The first 10 cues of the chase are loaded into the playback
faders.
3> Raise a playback fader to output the contents of that cue (fade
times will operate as programmed).
4> Various Unfold options are available, the details are below.
5> Press Unfold again to get out of unfold mode.
• To edit the contents of a cue: Press Clear to empty the
programmer, raise the fader to output the cue, make the
changes, press [Record Step], then the Swop button for the cue
number.
• To Insert a new cue at the end of the chase, set up the look for
the new cue, press [Insert Step], then press the swop button of
the first free playback.
• To Insert a cue between two other cues, set up the look for the
new cue, press [Insert Step], then type the cue number for the
new cue (such as 1.5 to go between 1 and 2). If this cue
number already exists it will be merged with the look you have
created. Otherwise a new cue is inserted.
• To change individual times for the cue, press [Edit Times], then
the Swop button for the cue (or type the cue number), then set
the times. This is described in detail in the Timing section on
the following page.
• If the chase has more steps than there are playback faders, you
can go between pages using the [Previous Page] and [Next
Page] buttons.
Comments to this Manuals