Avolites Pearl Expert Titan Operator's Manual download pdf (Page 15)

1. Quick Start - Page 15

TitanUniversal_Man_v7-0_PE.doc 02 September 2013

[Fixture Overlap] sets each fixture to fade in sequence (100%=all

together, 0%=fixture waits for previous one to complete).

[Attribute times] sets individual fade times for different attributes.

[Fixture order] changes sequence for shapes and Overlap. (Section

8.5, p151).

Cue Lists

Cues may be stored in a Cue List which allows a full show to be run

from a Go button. Chases can be included using Autoload.

1.4 Programming palettes

Set up the attributes to be recorded. If attribute is the same for all

fixtures of one type (e.g. colour), only one fixture need be set up and

palette will be “shared”.

Press Record Palette.

Use [Set Mask] to choose attributes to record/exclude.

Press a grey palette button to store, or press a button in one of the

Colours/Positions/Gobos windows. (Section

5.1.2, p84).

To recall palette, select fixtures, select recall mask using Attribute

Bank buttons, press palette button.

To set a legend, press [Set Legend] then the palette’s button. Press

[Picture] to draw a picture legend.

Quick Record

Press an unused button in one of the windows – the button turns red

with a +. Press again to save the palette. The mask is automatically

set to match the window (e.g. Positions window is masked for only

position attributes).

Busking with palettes

To fade palettes when busking a show, select fixtures, type fade time

on the keypad then recall the palette (you have to do this each time).

If no fixtures selected, palette will recall to all applicable fixtures.

To set fixture overlap, type 0-100 then press [Set Overlap], then

recall the palette.

To set a fade time for all palettes, press Palette then [Master Time].

(Section

5.5, p92). Faded palettes do not go into the programmer so

don’t use fades when programming.

1.5 DMX / network setup

The console can output up to 12 universes of DMX (called DMX Lines)

which may be routed to the 4 XLR sockets or over Ethernet. The Pro

versions of Pearl Expert and Tiger Touch can output 16 Universes.

The Titan One dongle is limited to a single universe. By connecting

further DMX processing nodes to the network using TitanNet, you can

control up to 64 universes.

Switch to System mode, press [DMX Settings].

Select a Node on the left (where the DMX is going to), click the blue

arrow. On the right, select the DMX line it will be fed by. The ‘i’

buttons set properties for Nodes/Lines. (Section

5.5, p200).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 259 260

Comments to this Manuals

No comments

Avolites Pearl Expert Titan Operator's Manual Page 15

Comments to this Manuals

Related products and manuals for Recording Equipment Avolites Pearl Expert Titan